Question 1

What is a silicon nitride ball?

Accepted Answer

A silicon nitride (Si3N4) ball is a precision ceramic rolling element made by sintering fine silicon nitride powder with sintering aids (yttria, alumina) into a dense, gray-black bead. Si3N4 is the standard 'bearing-grade' ceramic - it offers the best combination of low density (3.20 g/cm³), high strength (HV 1500+), thermal stability up to 1100 °C, and electrical insulation.

Question 2

What is silicon nitride made of?

Accepted Answer

Silicon nitride is a ceramic compound of silicon and nitrogen (Si3N4), usually sintered with 3-8 % yttria (Y2O3) and 2-5 % alumina (Al2O3) as liquid-phase sintering aids. The final microstructure shows elongated beta-Si3N4 grains embedded in a glassy grain-boundary phase, giving a balance of hardness, strength and fracture toughness needed for rolling-element duty.

Question 3

How hard is a Si3N4 ball?

Accepted Answer

Bearing-grade silicon nitride is Vickers HV 1450-1700 (HRC equivalent ~78-80), nearly twice as hard as through-hardened 52100 chrome steel. Crucially, hardness is retained at temperatures that would soften steel to near-annealed condition. Knoop or Vickers micro-hardness is the standard measure - never Rockwell C, which damages the surface.

Question 4

What is the density of silicon nitride?

Accepted Answer

Density of Si3N4 is 3.20 g/cm³ (0.115 lb/in³), about 60 % lighter than steel (7.8 g/cm³). This is the largest single advantage in high-RPM bearings: lower centrifugal force at the outer race, allowing 30-100 % higher speed limits than all-steel bearings of the same envelope.

Question 5

What temperatures can Si3N4 balls handle?

Accepted Answer

Si3N4 balls operate continuously from -100 °C to +1100 °C with no oxidation or phase change. Brief peaks to 1400 °C are tolerated. Mechanical strength is best between 200-1000 °C; below -100 °C some grades show reduced fracture toughness, so cold applications often stay with steel or SiC.

Question 6

Are Si3N4 balls corrosion resistant?

Accepted Answer

Silicon nitride is chemically inert to most acids, alkalis, salts and organic solvents. It resists hydrochloric, nitric, sulfuric and most organic acids. Hydrofluoric acid and strong hot caustic can etch the grain-boundary phase, so SiC or alumina is preferred in those services. Si3N4 does not require passivation and never rusts.

スチールボールに関するよくある質問

Frequently asked questions